With the coronavirus running rampant through the world, I’ve been making a lot more coffee at home. The Starbucks, Perks and other local coffee shops are open, but only for take out or drive-thru. After several years of using mainly the French Press method, I switched to Chemex. Here is my routine for making coffee each morning for my spouse and myself.
- Traditional 10-Cup Chemex
- Chemex square bonded filters
- OXO digital food scale
- Pour Over gooseneck kettle
- Heihox manual stainless steel burr grinder
- Coffee – Usually from Trade Coffee subscription unless my friends from Seattle hook me up with some Anchor or Cafe Lladro.
I begin by measuring 1100 grams of filtered water into my kettle, and then set it on the stove to boil. I then measure 62 grams of coffee beans and hand-grind them at a medium to course setting. I set the ground beans aside and prepare my Chemex. I’ve found folding the Chemex filters down the middle helps keep it in place when I begin my pour-over.
One reason I like the Pour Over gooseneck kettle is because it includes a thermometer on the lid. When the water reaches just past 200 degrees Fahrenheit, I pull it off the stove. I then put my Chemex with filter on my scale and tare it before I pour 100 grams of water over the filter. This rinses away any paper taste from the filter and helps warm the Chemex vessel.
Dump the water from the Chemex, and then carefully place your coffee grounds into the filter. Tare the scale again, and slowly pour about 120 grams (or twice the amount of coffee) over your beans, make sure to cover them all. The goal here is to allow the water to release the carbon dioxide from the beans and prepare them for the pour over. Let the coffee bloom for about 30-40 seconds.
Then take your kettle and slowly pour about another 400 grams worth of hot water over the beans. I’ve found making smallish circles with the gooseneck allows for a more even extraction of beans. Take a spoon or bamboo stick and gently stir the slurry to make sure there’s no clumping going on. Then pour the rest of the water using the same circular motions.
The entire pour-over, from start to finish, should take about 3:30 to 4:30 minutes, although don’t stress too much if you take a little longer. I’m probably taking closer to 5 minutes most mornings, but that could be because I’m barely awake before my first cup.
I allow the coffee to brew until I see it begin to drip from the filter before tossing it in the trash. I then give the fresh coffee a quick stir before enjoying it with a few ounces of half-and-half. If you’ve used good quality coffee, give it a taste test before adding a lot of sweeteners. You might find the flavors of the coffee are enough to please your palate.